Straw Beds can become half-beds and overlap when many are placed quickly

When placing many Straw Beds very quickly and in random positions/orientations on the ground, occasionally a Straw Bed can be placed in an incorrect state. Only half of the bed is visible, and another Straw Bed can overlap/intersect it.

The half-bed can remain in the world. I was also able to sleep in one of the beds while the unusual overlapping arrangement was present.

I have not been able to reproduce the issue every time. It appears to be intermittent and may require placing many Straw Beds very quickly.

Steps to Reproduce:

1. Create or enter a world.

2. Get Straw Beds.

3. Find a flat area.

4. Quickly place many Straw Beds across the ground.

5. Place them rapidly and in different/random orientations.

Continue until one of the Straw Beds is placed incorrectly.

Expected Result:
Each Straw Bed should be placed normally, with both halves of the bed present, and beds should not incorrectly overlap each other.

Actual Result:
Occasionally, only half of a Straw Bed is visible. Straw Bed models can also overlap/intersect in an unusual way.

Reproducibility:
Intermittent. I have reproduced the unusual state, but I cannot reproduce it consistently.

Additional Information:
I first encountered the issue while doing a challenge where I was rapidly filling the floor with Straw Beds and cushions. I was placing the blocks quickly and randomly when I noticed the half-bed.

After discovering it, I tried to reproduce the same result again, but it did not happen consistently.

Screenshots showing the half Straw Bed and the overlapping beds are attached.