mojira.dev
MC-193949

The ender dragon will get confused if a water bucket is placed in the middle of the map

When placing water above the altar, the ender dragon is unable to perch and remains in a loop of spinning around the altar.

Steps to reproduce

  • Enter the end

    /execute in minecraft:the_end run tp @s 0 100 0
  • Place water above the altar. I used the following setup to consistently replicate it. Do not place water directly above the center of the altar as that leads to MC-207174

[media]
  • Wait until the dragon perches and observe that it starts spiralling around the altar instead of landing above the center block.

 

Linked issues

Attachments

Comments 10

[media]


I have tried reproing this, with water streams on different heights and on all sides of the portal, either on at a time or all at the same time. No repro.
Is there any additional information you can add? Perhaps attach the world where this happens?

This happened on a world when I was designing a video on creative mode to use for a spectator video. I do have the world, but unfortunately it would not allow me to send it due to it being about 80mb. It was several months ago when I made this, so I cannot recall much.

Alright. I managed to reproduce this eventually using two streams.
Wasn't easy though! 🙂

Affects 1.21.2 pre-release 1. Also would like to request ownership to maintain this report 🙂

i do not know how to transfer ownership.

 

This is an artifact of MC-272431 , the water pushes the ender dragon and due to its incorrect vertical velocity it cannot reach the block the water is on.

This should be fixed in 26.4 snapshot 8, please confirm if this is the case.

I can confirm it was fixed. I was able to replicate it in 26.4 snapshot 7 but not 26.4 shapshot 8

sof

(Unassigned)

Confirmed

1.16.1, 20w49a, 22w13a, 1.21.2 Pre-Release 1, 1.21.3, 1.21.4

Retrieved