The project [create a drawer for a desk/cabinet] calls for a frame to be attached to an object. The a door is attached to the frame to look like a handle. Finally using the shift key a banner is attached to the front of the frame with the door (handle) showing through. I'm not able to attach the banner.
What I expected to happen was...:
In the project descripted above, the banner (using the shift key) should attach to the frame with the door (handle) showing through. There are other variations of this but the result is that whatever is in the frame comes forward through the banner.
What actually happened was...:
The banner will not attach to the frame. If I put banner on frame instead of door in sits within the frame.
Steps to Reproduce:
1. Place 2 blocks; one on top of the other
2. Place a frame on the front side of each block
3. Place a door or half slab into the frame. This is the drawer handle
4. Place a banner (or sign) on top of the frame so that it covers the frame but the door/half slab (handle) comes forward through the banner
Comments 3
This issue has not been resolved. Apparently I there is a bug with my F3 as well. How else can I provide the needed information to you? I will have to create a separate report for the F3 issue.
Please provide some screenshots or videos of this issue occurring whilst the F3 debug screen is enabled.