New Rabbits are too big, and can therefore push each other over fences.

Greetings! So, because my friend encouraged me to not be as complaining today, I decided to actually go ahead and try out the new snapshot. Worst case scenario, I thought, is that I still despise the new rabbits for not having preserved Programmer Art Textures.

Anyways, went to try it out, and immediately realized a terrible flaw with the new rabbits, or, rather, my pen for holding them. You see, my pen for my rabbits had been rather small, I’d say about 5x5 in size, if I remember correctly, and because the new rabbits are so large in comparison to the older ones, they were able to push into each other, causing them to jump higher than normal, and thus out of the paddock. I resolved this by adding two extra rows of oak fences to the paddock, on top of the ones already there. However, I ran into some issues:

Firstly, my poor spawn egg wall, which is partially along the back side of the rabbit paddock, now has a fence where there should be the zoglin spawn egg, in it’s item frame, which now can’t be there due to the need for higher than usual fencing.

Secondly, is that now it shall be a lot more difficult for me to get in and out of the paddock too, as when the fences were only one fence tall, due to my beacon array providing jump boost II, I was able to just jump over the fences. Now, however, I can’t do that, as jump boost II isn’t strong enough to propel me over the now three fence tall fence.

So, because of the issues described above, I should like to personally request either these new rabbits be shrunk down by a factor of 0.5, (as I personally feel they are about 1.5 times the size they should be), or be made so they can’t push each other into jumping high enough to clear fences.

Anyways, that’s all, Rockatoa, Brickticks out!