[MC-55781] clone command doesnt work well with pressure plates

i was going to have screenshots, but its kinda hard to show. plus it would take like 5 screenshots or something. but i was gonna make a device with the new clone feature, the move part. and i would activate the command with pressure plates. i noticed that cloning towards the +z axis, the pressure plate wouldnt come back up. it would be stuck in the pressed state fore ever. but on the -z axis the pressure plate will come back up. this is obviously a bug. though im not sure which one is the bug. im assuming its the +z axis, as it doesnt ever come back up. please say if im lacking information. thanks

Linked issues

duplicates 1

MC-49010 Cloning pressure plates or buttons whilst they're activated keeps them pressed forever Resolved

Attachments

Comments 7

Dlawso the Really Lucky Rabbit 2014-05-24T14:12:48Z

Please attach screenshots either by doing F2 or FN+F2

qmagnet 2014-05-24T14:41:54Z

That's because you've cloned a pressed pressure plate (block:stone_pressure_plate 1). Unless the plate gets a block update, it will remain pressed).

qmagnet 2014-05-25T13:00:49Z

Provide a screenshot or a mod should mark this as works as intended.

jimbo1258 2014-05-27T20:49:13Z

the blue wool represents the side that the pressure plate wont come back up, while the gold represents the side that does

jimbo1258 2014-05-30T19:32:06Z

so, i can only step one the blue pressure plate once, while i can step on the gold one multiple times

Mustek 2014-05-30T19:35:42Z

This issue has been reported already. It has been linked to the original bugreport.
Please search before reporting any bugs, as it's likely that one exists already.

jimbo1258 2014-06-03T00:51:27Z

well, there are a ton of issues to filter. it makes it a bit harder. and i reported one command where the pressure plate would come back up, while on a other, the pressure plate stays.