After editing a command block that has been set, it bugs and doesn't proceed to execute the provided command even though its on Always Active and Repeat, with default tick speed.

Once I've created my command block and go back and edit the command it bugs out and doesn't proceed to execute the provided command even though its on Always Active and on Repeating, with default tick speed

This only has occured to me after I edit the current text within it. this only effects repeating command blocks as far as I'm concerned but to be sure check, and the only way I been fixing it manually was setting it to Needs Redstone, leaving the command and going back in and turning it to Always Active again.

Making this issue occur is simple:

1. Create a Repeating command block and set it to Always Active

2. Type a command into it

3. Exit the command then re-enter it

4. Edit the text within the command

5. Repeat step 3

And just like that you now have a bugged repeating command block that refuses to execute commands until manually debugged. please fix the issue microsoft.