When you build the contraption seen in the screenshot and stand at the empty point between all the other blocks you will sometimes get moved into the blocks on the left side and when you place a slab as block 2 (The place of that grass block where you clip in) and then crouch you will have an X-ray glitch. I don't know if this is already being tracked, but I searched for it sorry if this is not clear enough.
Steps to reproduce:
Build a 3x3x3 chamber that is two blocks tall out of any block
Hollow out the chamber in the middle
Place two pistons behind one of the four walls you can see from inside the chamber
Replace one of the wall blocks with a lever/button that connects to the piston
Press/pull the button/lever
View the image down here for the setup I used.
[media]Attachments
Comments 8
Thank you for your report!
However, this issue has been temporarily resolved as Awaiting Response
Is this still an issue in the latest version?
If it is, please be sure to include steps to reproduce the problem:
Steps to Reproduce:
1.
2.
3.Observed Results:
(Briefly describe what happens)Expected Results:
(Briefly describe what should happen)
If your ticket does not look like the example given here, then it's likely to be closed as incomplete.
This ticket will automatically reopen when you reply.
Quick Links:
📓 Issue Guidelines – 💬 Mojang Support – 📧 Suggestions – 📖 Minecraft Wiki
Cleaning up old tickets: This ticket had been set to 'Awaiting Response', but has not received a response from the reporter (~3 months+) so is being closed as Incomplete. If you feel this is still a valid issue then please comment, or create a new ticket following the Issue Guidelines which includes steps to reproduce the problem.
Quick Links:
📓 Issue Guidelines – 💬 Mojang Support – 📧 Suggestions – 📖 Minecraft Wiki
I don't know if this is the exact same issue you have, but I have a similar (if not same) issue that I randomly found.
Steps to reproduce:
Place down a sideways sticky piston
Dig a 1 block hole in front of the piston and fill with water, lava, or nothing
Place any block on the front of the sticky piston
Place lever next to sticky piston
Pull lever
Once the piston is extended, stand on the piston arm (the part that does the extending)
Pull the lever again and walk forward
Your camera/head should be inside of the block you placed on the piston. If you want to exit, dig another hole next to the water block and place a slab down.