Monty Wild
Assigned
Reported
MCPE-131836
Lightning Rods less likely to attract lightning during a thunderstorm when at higher altitudes.
Cannot Reproduce
MCPE-93673
Can't connect to Code Connection
Incomplete
MCPE-62200
Structure Block bounding box 'off' toggle not honored until block activated by redstone or GUI accessed.
Duplicate
Comments
Yes, this is still an issue in 1.18.2.
No change in behavior since 1.17.11
I have confirmed that the redstone ladder/repeater circuit is operational by using a lever on the block to which the lightning rod is attached, however lightning does not appear to strike this high-placed lightning rod in the time that the ground-level lightning rod is struck 10 times or more.
I can confirm that this issue still exists in 1.17.11.
I have a bell in the y:~120 tower, as well as a repeater loop that will lock on in the event of a lighning strike.
I also set up a similar arrangement at y:~6 in an adjacent chunk.
In the time that I had to reset the repeater loop roughly 10 times in the y:~6 tower after lighning strikes, I did not have to reset the loop at the base of the y:~120 tower even once.
Either lightning was not striking the y:~120 tower, or for some reason, the lightning rod was not activating the redstone ladder assembly as the lever attached to the block supporting the lightning rod does.
no settings were altered.
Lightning still doesn't hit the high lightning rod, even when all lower lightning rods in the same and nearby chunks broken. Low rod struck within seconds of being placed.