The /clone command, if I understand correctly, copies the selected area with opposite corners (x1,y1,z1) and (x2,y2,z2) to the new area such that (x1,y1,z1) is moved to (x,y,z). However, even though the two areas are nowhere near each other, I'm still getting the "Source and destination cannot overlap" error message.
If it matters, the blocks I'm copying are Polished Andesite, Fence posts, wooden doors, stone pressure plates, stone brick stairs, and air.
Comments 7
Also, please don't put down the affected version as a future version. You DON'T have access to it yet!
@FVbico: /clone 186 3 898 174 3 887 150 3 887. I didn't use the optional masked/replace mode tag at the end.
@Blah: To be precise, i'm using snapshot 14w21b. It's a 1.8 snapshot, and so 1.8 was the closest version in the pull-down. Besides, /clone is new to 1.8 I believe.
provide exact command please