Latest Version of Minecraft Bedrock Edition on PS4
Disclaimer:
There may be additional factors that contributed to the sudden appearance of this bug. However, at the time i was simply messing with scoreboard and replaceitem commands in "Chain" command blocks.
Steps to Reproduce:
1. /give @s command_block (Any kind of command block is fine).
2. Place, and access the command block.
3. Change the Type, Condition, or Activation Requirement of the command block (You can change all of these settings or just one of them).
4. Exit, and Re-enter the command block and see if the settings listed on the lower right side of the interface match the appearance and accessible settings on the left side.
5. Repeat steps 3 and 4 on any command blocks that have already been placed and activated in your world.
Observed Results:
Suddenly and without explanation, all further command blocks I placed, as well as those I had previously placed are stuck with certain settings. More specifically, the ones I previously placed cannot be changed from their current state. For example, if it is on "Repeat," I can attempt to change the setting on the left side of the interface to "Impulse," which will change the color of the block, but not the actual behavior, or text on the bottem right side of the interface. The same is true for whether or not it is conditional or requires redstone. All future command blocks become stuck as: "Impulse" "Unconditional" "Always Active". I can attempt change these settings in the block, but it will always behave using those three settings.
Expected Results:
The command block should change its behavior, and text on the bottem right side of the interface to match the settings that I have set on the left side of the interface. It is not entirely clear why the command blocks suddenly cannot be changed.
Maurice Badibanga
Latest Version of Minecraft Bedrock Edition on PS4
Disclaimer:
There may be additional factors that contributed to the sudden appearance of this bug. However, at the time i was simply messing with scoreboard and replaceitem commands in "Chain" command blocks.
Steps to Reproduce:
1. /give @s command_block (Any kind of command block is fine).
2. Place, and access the command block.
3. Change the Type, Condition, or Activation Requirement of the command block (You can change all of these settings or just one of them).
4. Exit, and Re-enter the command block and see if the settings listed on the lower right side of the interface match the appearance and accessible settings on the left side.
5. Repeat steps 3 and 4 on any command blocks that have already been placed and activated in your world.
Observed Results:
Suddenly and without explanation, all further command blocks I placed, as well as those I had previously placed are stuck with certain settings. More specifically, the ones I previously placed cannot be changed from their current state. For example, if it is on "Repeat," I can attempt to change the setting on the left side of the interface to "Impulse," which will change the color of the block, but not the actual behavior, or text on the bottem right side of the interface. The same is true for whether or not it is conditional or requires redstone. All future command blocks become stuck as: "Impulse" "Unconditional" "Always Active". I can attempt change these settings in the block, but it will always behave using those three settings.
Expected Results:
The command block should change its behavior, and text on the bottem right side of the interface to match the settings that I have set on the left side of the interface. It is not entirely clear why the command blocks suddenly cannot be changed.