Robert Mitchell

This is still the case with 1.14.2 pre-release 3

Minecarts in 1.13.2 were able to continue moving when the chunks for the track were covered by the /forceload command. This has not been the case in 1.14 or 1.14.1.

I tested this by doing the following...

1. Create a VERY long track

2. For each chuck, put in one detector rail over a command block.  The command block does a "/say <chunk number>"

3. Use the /forceload command to load the chunks that the rails pass through, and also forceload the chunks on either side of the rails.

4. Send a minecart down the rail. 

You will be able to see the chunk count as the minecart continues.  Once it is far enough away, the counting will stop. 

Move closer to the minecart and the count will continue.

Expected behavior: The minecart should traverse the entire track since all the chunks around it are forceloaded.

Actual behavior: The minecart gets as far as normally loaded chunks.  Once in the chunks covered only by the forceload command, the minecart will stop.