Steps to Reproduce:
[Step 1] place a sticky piston with a block
[Step 2] activate it (push the block)
[Step 3] deactivate it (pull the block)
Observed Results:
The sticky piston and the block disconnected, because the block doesn’t move at the same time with sticky piston
The piston’s head only changes/moves 4 times when pushing/pulling the block
Expected Results:
They should stick and move together
Notes:
When pulled, The sticky piston and the block only move half a block and just finish the move.
They don’t have any animation after pulled half a block
The piston’s pulling/pushing animations are not enough, The piston’s head only changes/moves 4 times when pushing/pulling the block
Linked issues
Attachments
Comments 8
Thank you for your report!
However, this issue has been temporarily closed as Awaiting Response
Is this still an issue in the latest version? If so, please make sure the ticket description contains the following information:
Steps to Reproduce:
1.
2.
3.Observed Results:
(Briefly describe what happens)Expected Results:
(Briefly describe what should happen)
If your ticket does not look like the example given here, then it's likely to be closed as incomplete.
This ticket will automatically reopen when you reply.
Quick Links:
📓 Issue Guidelines – 💬 Mojang Support – 📧 Suggestions – 📖 Minecraft Wiki
This issue, in particular, has been mishandled many times.
In short terms, the block movement animation doesn't synchronize with the piston/sticky piston, leading to jitter/not smooth animation or even for most times no animation at all. It happens generally speaking to everyone from higher-end devices and down.
Thank you for your report!
However, this issue has been temporarily closed as Awaiting Response.
Is this still an issue in the latest version? If yes, can you please add it to the affected versions (or mention it if you are not the reporter)?
This ticket will automatically reopen when you reply.
Quick Links:
📓 Issue Guidelines – 💬 Mojang Support – 📧 Suggestions – 📖 Minecraft Wiki
This issue still exists in 1.18.31, but in a different form now.
Now, the block movement animation is almost non-existent. I believe this is being tracked in MCPE-146597.
The piston arm animation still visually goes inside the block or separates from the block with the missing block animation (MCPE-146597). From what I can tell the piston arm animation was always more fine-grained than the block animation in earlier versions (4 steps vs 2), so they have never been in sync.
This also happens on android 10