Sculk sensor wool occlusion has directional bias

https://v.redd.it/4zmhluw0qb361/DASH_720.mp4?source=fallback

here is another 55 second video with some additional information. as you can see the wool works different on different cardinal directions. but the problem goes a little further, in the end of the video it's showcasing that the wool block even work different on some coordinates. there are certain coordinates with weird behaviors, x=81 z=8 is one of those.

Is this still an issue in snapshot 21w05a or later?

Can confirm in 21w05a that this is still an issue.

Can confirm in 21w05b.

Can confirm in 21w06a.

Can confirm in 21w07a.

Can confirm in 21w11a.

Can confirm in 21w14a.

Can confirm in 21w16a.

Can confirm in 21w17a.

Confused

Can confirm in 1.17.

Can confirm in 1.17.1.

Can confirm in 21w42a.

Can confirm 1.18 pre-5

If you look at this image:

The way of checking for wool is by doing something known as a raycast. It's a line that checks for every block that it intersects. Although when going at a perfect 45 degree angle you run into a problem. A raycast is only able to interact with a single block at any point on the ray.

So the solution around this is simply to check the other block that would not have been hit. We do this by first checking if the ray is at a 45 degree angle, if it is then we check the block at the same position but switch the x & z to get the opposite side.

Working Fix

Can confirm in 1.18.1.